Hi all,
I'm just learning at this point and looking for criticism. This is a train station here in Worcester MA. I am using gigapan head with the gigapan stitch software prior to coming into Pano2VR. 50% overlap. FOV 26.1. 50mm 1.4 on 5D Mark III. Raw to JPG without color correction. Some issues with floor pattern are noticeable.
I am not convinced I have the correct "projection?" of the stitched image when I come into pano2vr. PanoVR is recognizing these images as Cylinders. The walls look ok enough but the floor and ceiling are very distorted. Any feedback and suggestions welcome. Previews and links to hosted versions below.
- Brian
Feedback on first projects
-
- Posts: 6
- Joined: Fri Mar 01, 2013 1:56 pm
Last edited by BWilkinson on Fri Mar 15, 2013 1:08 am, edited 1 time in total.
-
- Posts: 6
- Joined: Fri Mar 01, 2013 1:56 pm
Appears that I was creating Equirectangular out of Gigapan Stitch but wasn't selecting Equirectangular as an input type in pano2vr. Things are looking much better now. - Brian
Pano2VR will auto detect Equirectangular image on input, so long as the file is 2:1 aspect ratio (exactly twice as wide as hight in pixels)
Odd pixel either direction will cause it to fail. I.E 10000x5000 = Equirectangular 99999x49998 = Fail
Regards, Smooth
www.omnipix.com.au
Odd pixel either direction will cause it to fail. I.E 10000x5000 = Equirectangular 99999x49998 = Fail
Regards, Smooth
www.omnipix.com.au